Jockey Pump for Fire Fighting Systems in Mumbai

A slim vertical jockey pump with a red motor on top, standing on a concrete plinth

Cease Fire & Electrical Services LLP supplies, installs and services the jockey pump for fire hydrant and sprinkler systems in Mumbai. A jockey pump is a small pressure maintenance pump that keeps the fire pipework at its set pressure and makes up minor leakage, so the main fire pump starts only when a hydrant or sprinkler actually opens. We supply jockey pumps in end suction back pull-out, split casing and vertical designs, matched to your main pump and system pressure.

What a jockey pump does

Fire pipework is kept full of water under pressure at all times. Small losses from joints, valves or temperature changes slowly lower that pressure. The jockey pump starts on its own at a set pressure, tops the system back up and stops again.

The jockey pump is set to start at a higher pressure than the main pump. A small drop is handled by the jockey pump alone. When a hydrant is opened or a sprinkler operates, the pressure falls much further and faster than the jockey pump can make up, and the main fire pump starts. The jockey pump does not supply fire fighting flow itself.

Jockey pump designs we supply

  1. End suction back pull-out

    Horizontal pump; the motor and impeller can be taken out for service without removing the suction and delivery pipes

    Flow, head and motor rating

  2. Split casing

    Casing opens in two halves so the impeller and bearings can be inspected in place

    Flow, head and motor rating

  3. Vertical

    Upright pump with a small footprint, for pump rooms with little floor space

    Flow, head and motor rating

We confirm the right design, pressure and motor for your system before quoting.

What to tell us

System served
Hydrant, sprinkler or both
Main pump duty
The jockey pump is chosen to suit the main pump and its start pressure
System pressure
The pressure the pipework must hold when idle
Pump room space
Decides between a horizontal and a vertical pump
Existing panel
Whether the jockey pump connects to an existing fire pump control panel

Where jockey pumps are used

  • Engineer checking a hose reel cabinet in the lift lobby of a residential tower

    Residential towers and housing societies

  • Engineer looking up at a ceiling smoke detector on an open-plan office floor, a call point and extinguisher on the column beside him

    Commercial buildings, offices and malls

  • Engineer testing a ceiling smoke detector with a pole tester in a hospital corridor

    Hospitals, hotels and schools

  • Two engineers walking a factory production floor past a red hydrant post and hose reel cabinet

    Factories and warehouses

  • Engineer walking a row of three red fire pumps in a basement pump room, a control panel at the side

    Any building with a fire pump room serving hydrants or sprinklers

Supply, installation and servicing

We supply the jockey pump, install it with its pressure switch and valves, and set its start and stop pressures together with the main and diesel pumps. During AMC visits we check how often it runs. A jockey pump that starts and stops very often usually points to a leak or a passing valve in the system, which we trace and fix.

Under the Maharashtra ACMS rules of 12 June 2025, covered buildings must monitor pump status continuously. Our FireSense IoT panel reports jockey, main and diesel pump status and riser pressure every minute, and a jockey pump that starts too often shows up in that data. See the ACMS guide.

Technician kneeling by a red fire pump, checking its pressure gauge against a service sheet

Why choose Cease Fire

  • Since 1992

    A Maharashtra Fire Services Licensed Agency (MFS/LA/RF-93/RD-95).

  • The whole pump set

    Jockey, main electric and diesel engine pumps from one team, set up to work together.

  • Service after supply

    Commissioning, AMC visits and Form B certificates by the same engineers.

Request a quote

Share your pump schedule, main pump duty or a photo of your existing jockey pump nameplate. We will recommend the right pump and send a quote.

Frequently asked questions

What is a jockey pump in a fire fighting system?

A jockey pump is a small pump that keeps the fire pipework at its set pressure. It makes up minor leakage so the main fire pump starts only when water is actually drawn.

What is the difference between a jockey pump and a main fire pump?

The main pump delivers the full flow the hydrants and sprinklers need during a fire. The jockey pump only maintains pressure and is much smaller.

Can a jockey pump put out a fire?

No. It is sized only to make up small pressure losses. Fire fighting water comes from the main electric pump, backed up by the diesel engine pump.

Why does my jockey pump keep starting and stopping?

Frequent starts usually mean the system is losing pressure through a leak, a passing valve or a faulty pressure switch. We find and fix the cause during a service visit.

Which type of jockey pump do I need?

It depends on your system pressure, main pump duty and pump room space. We supply end suction back pull-out, split casing and vertical designs and recommend one after reviewing your system.

Can you replace a jockey pump in an existing pump room?

Yes. We check the existing settings and connections, supply a matching pump and set it up with your main and diesel pumps.

Can the jockey pump be monitored remotely under ACMS?

Yes. FireSense IoT monitoring reports pump status and riser pressure every minute, which supports the ACMS required for covered buildings in Maharashtra.

Question not answered here? Call our team, Monday to Saturday, 9 am to 7 pm.

Call +91 9920676281